For mounting on the M8 thread of the shooter rod (between the short spring and the knob).
This washer mainly protects plastic knobs from the sharp edge of the spring.
Since a large punctual force is applied to the button by the spring, it may under certain circumstances damage / breakage of the plastic, preferably with round knobs.
Our washers have an optically high-quality surface.
inner diameter 8,5mm / outer diameter 15,7mm
If you need rings on the other side of the shooter rod (before and after the long spring), you'll need these:
Washer 0.390" x 0.625" x 0.059" for Shooter Assembly
No posts found